Thursday, August 21, 2014

New Plastic Pipe Standards for the 2nd Quarter 2014

Document Center Inc. is pleased to announce that the following New Standards on Plastic Pipes are now available:


  • ASTM D2513, 2014 Edition with Editorial Correction, Standard Specification for Polyethylene (PE) Gas Pressure Pipe, Tubing, and Fittings
  • ASTM D2665,  2014 Edition, Standard Specification for Poly(Vinyl Chloride) (PVC) Plastic Drain, Waste, and Vent Pipe and Fittings
  • ASTM D3296, 2014 Edition, Standard Specification for FEP-Fluorocarbon Tube
  • ASTM D3681, 2012 Edition with Editorial Correction, Standard Test Method for Chemical Resistance of 'Fiberglass' (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe in a Deflected Condition
  • ASTM D3839, 2014 Edition, Standard Guide for Underground Installation of 'Fiberglass' (Glass-Fiber Reinforced Thermosetting-Resin) Pipe
  • ASTM F1504, 2014 Edition, Standard Specification for Folded Poly(Vinyl Chloride) (PVC) Pipe for Existing Sewer and Conduit Rehabilitation
  • BS ISO 4427-2, 2007 Edition with Amendment A1, Plastics piping systems. Polyethylene (PE) pipes and fittings for water supply. Pipes
  • BS ISO 8513, 2014 Edition, Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes. Test methods for the determination of the apparent initial longitudinal tensile strength
  • BS ISO 10952, 2014 Edition, Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Determination of the resistance to chemical attack for the inside of a section in a deflected condition
  • BS ISO 17484-1, 2014 Edition, Plastics piping systems. Multilayer pipe systems for indoor gas installations with a maximum operating pressure up to and including 5 bar (500 kPa). Specifications for systems
  • ISO 4427-2 Amendment 1, Amendment 1 for 1st Edition, Polyethylene (PE) pipes and fittings for water supply - Part 2: Pipes, Plastics piping systems
  • ISO 8513, 2nd Edition, Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Test methods for the determination of the apparent initial longitudinal tensile strength
  • ISO 8779 Amendment 1, Amendment 1 for 3rd Edition, Plastics piping systems -- Polyethylene (PE) pipes for irrigation -- Specifications
  • ISO 10952, 3rd Edition, Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes and fittings - Determination of the resistance to chemical attack for the inside of a section in a deflected condition


For more standards like these, see our Document Center List of Standards on Plastic Pipes.

And you'll also want to take a look at my previous blog: