- ASTM D1598, 2015A Edition, Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
- ASTM D2852, 2016 Edition, Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
- ASTM F449, 2016 Edition, Standard Practice for Subsurface Installation of Corrugated Polyethylene Pipe for Agricultural Drainage or Water Table Control
- ASTM F667, 2016 Edition, Standard Specification for 3 through 24 in. Corrugated Polyethylene Pipe and Fittings
- ASTM-F1055, 2015 Edition, Standard Specification for Electrofusion Type Polyethylene Fittings for Outside Diameter Controlled Polyethylene and Crosslinked Polyethylene (PEX) Pipe and Tubing
- ASTM F1412, 2016 Edition, Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
- ASTM F2023, 2015 Edition, Standard Test Method for Evaluating the Oxidative Resistance of Crosslinked Polyethylene (PEX) Pipe, Tubing and Systems to Hot Chlorinated Water
- BS EN ISO 9967, 2016 Edition, Thermoplastics pipes. Determination of creep ratio
- BS EN ISO 9969, 2016 Edition, Thermoplastics pipes. Determination of ring stiffness
- BS ISO 21307, Corrigendum 1 for the 2011 Edition, Plastics pipes and fittings. Butt fusion jointing procedures for polyethylene (PE) pipes and fittings used in the construction of gas and water distribution systems
- BS ISO 8513, 2016 Edition, Plastics piping systems. Glass-reinforced thermosetting plastics (GRP) pipes. Test methods for the determination of the initial longitudinal tensile strength
- ISO 8513, 3rd Edition, Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Test methods for the determination of the initial longitudinal tensile strength
- ISO 9967, 3rd Edition, Thermoplastics pipes - Determination of creep ratio
- ISO 9969, 3rd Edition, Thermoplastics pipes - Determination of ring stiffness
For more standards like these, please refer to our Document Center List of Standards on Plastics Pipes.
